Porima TPU Filament
Porima TPU Flex® Filament
Porima TPU Filament
Porima TPU Filament
Porima TPU Filament
Porima TPU Filament
Porima TPU Filament
Porima TPU Filament
Porima TPU Filament
Porima TPU Filament
Porima TPU Flex® Filament
Porima TPU Flex® Filament
Porima TPU Flex® Filament

Porima TPU Flex 95A Filament (PFTPU1MAVR50151755G)

Brand : porima
Price : €40,00
Excl. VAT : €40,00

Porima TPU Flex ShoreA95 Filament

Porima TPU Flex (ShoreA95) Filament has easy printing, high chemical resistance and high flexibility. It is an engineering material specially designed for applications where high toughness and impact resistance are required. Its flexibility can be adjusted according to the filling rate. It can be used in indirect (Bowden) and direct (Direct Drive) extruders.

Porima TPU Flex Filament
 
Extruder Temperature

Extruder Temperature

220-240°C

Does not require special "Hot-end"

Bed Temperature

Bed Temperature

50-70°C

Can be turned off optionally

Nozzle

Nozzle Specs

0,4 mm nozzle

Standard brass can be preferred

 
Cooling

Cooling Specs

Fan Speed: 100%

Cooling fan required

Drying

Drying Specs

65°C for 4 hours

Maximum value when needed

Heated Chamber

Heated Chamber

Suitable for open printers,

Does not require a closed or heated chamber

 
Porima TPU Flex Filament

Physical and Chemical Properties

  • Shore 95A flexibility
  • High elongation over 500%
  • Ease of printing compared to similar flexible materials
  • High chemical resistance
  • Excellent layer adhesion
  • Exceptional fatigue resistance
  • Very low odor emitted during printing
  • Low moisture absorption
  • Maintaining flexibility at low temperatures
  • Free of styrene and BPA
 

Porima TPU Flex Usage Details

 
Printing Difficulty Difficult
Temperature Resistance 70 °C
Toughness Very High
Warping No
Odor No
Print Surface Finish Very Difficult
Dissolution Behavior Very Difficult
Flexibility High
Print Speed Low
Detailed Print Below 0.2 mm
Nozzle Abrasion None
Support Separation Difficult
 

NOTE:

It may be necessary to loosen the extruder thrust gears as much as possible before printing. It will be enough for the gears to be tightened to a level that can pull the TPU Flexible filament and make contact. In the slicing settings, the retraction value should be at the minimum level or off. Drying the exposed filament can improve print quality. (Drying: 65°C for 4 hours) Print speed is recommended in the range of 20-40 mm/s.

 

Box Capacities

Porima Box Capacities
 
 
 
 
 
cultureSettings.RegionId: 0 cultureSettings.LanguageCode: EN