Thanks to the special silvery structure of Porima PLA Star® Filaments, the layer lines on the prints appear smoother. Since it has the same properties as Porima PLA® Filaments, prints with excellent surface quality can be obtained.
Extruder Temperature
200-230°C
Does not require special "Hot-end"
Bed Temperature
60-75°C
Can be turned off optionally
Nozzle Specs
0,4 mm nozzle
Standard brass can be preferred
Cooling Specs
Fan Speed: 100%
Cooling fan required
Drying Specs
50°C for 4 hours
Maximum value when needed
Heated Chamber
Suitable for open printers,
Does not require a closed or heated chamber
NOTE:
There may be a risk of nozzle clogging due to the glitter reinforcements in it, therefore it is recommended to use 0.4 mm and above nozzles.
This website has been built by Ticimax® Advanced E-Commerce .
Internet Explorer tarayıcısının 9.0 ve daha eski sürümlerini desteklememekteyiz. Web sitemizi doğru görüntüleyebilmek için tarayıcınızı güncelleyebilirsiniz, güncelleyemiyorsanız başka bir tarayıcıyı ücretsiz yükleyebilirsiniz.